Barter's
I am turning a large (for me) burl I got from the site. I don't recall who it as.
I have included several pictures the question is: Should I trim off more on the bandsaw? It is 10 inches across about 3-4 inches high. There is a bark inclusion of the bottom that is at least 1 1/2 inches deep.
Note bottom hole in pictures 4-5. I like bark inclusions so I would like to keep some. These pictures show that I have been attacking it on the lathe, slow speed. Let me here some ideas.
As always Thanks
John
I am turning a large (for me) burl I got from the site. I don't recall who it as.
I have included several pictures the question is: Should I trim off more on the bandsaw? It is 10 inches across about 3-4 inches high. There is a bark inclusion of the bottom that is at least 1 1/2 inches deep.
Note bottom hole in pictures 4-5. I like bark inclusions so I would like to keep some. These pictures show that I have been attacking it on the lathe, slow speed. Let me here some ideas.
As always Thanks
John