Marblewood pen

keepanionme

Member
Full Member
Messages
191
Reaction score
310
Location
Harrisburg PA
First name
Jim
This pen was created from marble wood with a gun metal plated fittings and is finished in CA. Notice it has a pretty distinctive, ergonomic lower barrel that makes writing with it very comfortable.

I'm open for pen blank sized burl wood trade ( 7/8" x 7/8" x 5"), or will sell it for $25 shipped in the continental US.

002.JPG 003.JPG 004.JPG 005.JPG 006.JPG
 
Last edited:

ripjack13

ɹǝʇɹɐqpooʍ
Staff member
Administrator
Global Moderator
Full Member
Messages
30,832
Reaction score
37,713
Location
Connecticut
First name
Marc
Very Nice!!! I like that lil flair for the grip. What kind of kit is that?

I made one for my brother using a slimline and I crosscut the marblewood. Have you tried using it crosscut?
 

keepanionme

Member
Full Member
Messages
191
Reaction score
310
Location
Harrisburg PA
First name
Jim
  • Thread Starter Thread Starter
  • #3
Thank you. That is a designer kit.

I've not had much luck with crosscut lumber. I always seem to have the ends chip out on me. Although I haven't tried knocking off the corners. I might do that and give crosscut another chance :)
 

ripjack13

ɹǝʇɹɐqpooʍ
Staff member
Administrator
Global Moderator
Full Member
Messages
30,832
Reaction score
37,713
Location
Connecticut
First name
Marc
Super glue the ends with the thin stuff. Let it soak in real good and take light cuts from the ends towards the center....lemme see if I have a pic...
 
Top