Hey guys,
I had a round bar of just straight line damascus I had forged a while back. Originally I had thought about doing a damascus pen but the rod was a bit big and I didn't want to turn off so much steel. Was lookin at it the other day and thought it might be big enough to make a ring. Figured it might be a fun lathe project.
Not too bad. I think it would be cooler with some swirly pattern going on though! And maybe a higher layer count
Dont mind my ugly fingers
I had a round bar of just straight line damascus I had forged a while back. Originally I had thought about doing a damascus pen but the rod was a bit big and I didn't want to turn off so much steel. Was lookin at it the other day and thought it might be big enough to make a ring. Figured it might be a fun lathe project.
Not too bad. I think it would be cooler with some swirly pattern going on though! And maybe a higher layer count
Dont mind my ugly fingers
Last edited: