Looking for round pieces of antler 1” plus in diameter for use in my ring making.
Shipping to Tennessee, 37129. Thanks
Shipping to Tennessee, 37129. Thanks
Antler shorts
- Thread starter Stan Mckinnon
- Start date
Hi Stan - I'm sure I can supply you with some. How long to you need the full 1" diameter to be? Would you prefer shorter pieces, or a full tine where the end is an 1"+ and tapers to the point for gipping it? Ballpark, how many pieces or inches of 1"+ material are you looking for?
The bases on these are all 1”+ at smallest dimension, but I could cut them off further up to give you the most usable material. I have more, but just pulled these out to give you an example of what I have that might work.
- Thread Starter Thread Starter
- #5
Thanks Steve. Length can be as little as 1” up to 6” ideally. With at least 1” round throughout the length. 15 pcs if shorts, 10 pcs if longer. More needed later. Many thanks
- Thread Starter Thread Starter
- #6
Photos look exactly what I’m speaking of Steve.
Will get some together and take pics for you Stan, but it will most likely not be until tomorrow as we're heading out in just a bit. I'm fairly sure my wife will have an issue if I start pulling out sheds right now 
If you still want more after Steve let me know.
- Thread Starter Thread Starter
- #9
No problem. I’m about to run a few honey-do’s my self, lol.
- Thread Starter Thread Starter
- #10
Will do. Thank you
Here’s another pic of what I think may work. John’s appear to be a bit larger in diameter and straighter as well, which I think may work better when mounting on the lathe.
Some of mine have a good deal of curve to them, particularly the third up from the bottom.
Some of mine have a good deal of curve to them, particularly the third up from the bottom.
If you still meed some, I can post some that fit your need.
i'd be interested in knowing what kind of price you would sell those antlers at
Sorry Trev, but Stan is taking these and I'll cut them later today for him. Are you interested in full antlers or cut offs? Let me know as I may have more that suit your needs, but none any larger than these that I'm willing to part with at the moment. I definitely have tines and some smaller ones if that helps.
Thanks again Stan and here is a pic of roughly where I was thinking of cutting them off at. Let me know if this works or I can cut them a little longer to allow you to trim them as desired.
Do you want the brow tines left on, ou would you like me to trim those off?
it was a broad generalization of question. i don't particularly need any of any sort but would buy some if the price was right. tines, parts bases or full antlers of any size
- Thread Starter Thread Starter
- #18
Sorry been off the 'net, so either is fine.
These are headed your way tomorrow Stan.
As I mentioned in our conversation, I found 1 more and 3 shorter pieces I thought may work so I’m throwing them in the box as well. I hope these work as you should be able to get a lot of rings from these. Be sure to post some pics of your finished stuff!
As I mentioned in our conversation, I found 1 more and 3 shorter pieces I thought may work so I’m throwing them in the box as well. I hope these work as you should be able to get a lot of rings from these. Be sure to post some pics of your finished stuff!
- Thread Starter Thread Starter
- #20
Awesome fellow. Those will work perfectly. I look forward to getting them in the mail.
Wishing you and yours the very best. Ty
Wishing you and yours the very best. Ty