Black wood

Mlyle

Mlyle

Amateur Woodturner
Full Member
Messages
974
Reaction score
401
Location
Bonney lake, Washington
First name
Michael
Looking for some African Blackwood...
very thin and and to be used as accenting in between pieces of small turned segmented boxes. or
I like to use them as beads on the layers of turned
boxes.

Thanks

MLyle
 
  • Thread Starter Thread Starter
  • #3
Ooh ooh getting very excited here!
The piece to the right of the yoyo looks nice!
But also looks like the thickness gradually becomes
Thinner?
Do you have a piece 3” wide ? 1/4” thick or so
I am most concerned with width.

but does appear the piece I need is in your pile
There.
And we can talk of length later.

thanks I am sure we can do business.
 
Mike give me exact measurement you need
 
Well Gowlllleeee (in my best Gomer voice). I do have a need for a piece minimum 1" thick (better up to 1.5") It could be less that 3' long or cut to fit in an inexpensive box. Then again, if you have some with dense growth rings, straight grain with little grain run out and minimum to no knots, preferrably quartersawn about 4" wide and at least 3' long (4' better) I would like 3
 
  • Thread Starter Thread Starter
  • #11
@pinky
Is that a big pile of Blackwood?
Did you have some pieces of Blackwood
at least 3 in wide?

I dont know if the picture answered my question?
 
@matthew seibert
The pieces do have sapwood. Once I know how many you want. I will post a picture for your approval. As I stated in the pm, these are 24" long. If 6" pieces are long enough, it will open up more options. Price was in the pm... per 24" piece.
 
  • Thread Starter Thread Starter
  • #18
correct me if i am wrong!!!

I was under the impression price had to be up front for all to see....

I inquired of the price back in May!
 
You must log in or register to reply here.
Back
Top