I have some cut off that are from quality blocks...Curly mango, maple burls and a curly spalted maple. Most are 3/8"ish thick. Didn't know if anyone could use them or not. Better to check than thrash it.
Stump
Stump
♫ εηdεd ♫ Curly mango, maple burls and a curly spalted maple.
- Thread starter stumpjumper
- Start date
Stump, what would you be looking to get for them? I've been making some pendants lately and since it looks like these are mainly cutoff slices from trimming call blocks, most of this material looks suitable for that purpose and that it would make some nice pendants. I usually start with a piece in the roughly 1 1/2" wide range, anywhere from 3/16" to 3/8" thick or so.
- Thread Starter Thread Starter
- #3
I went an measured the thickness and the thinnest is .460. Most are .480 and up. Also found a large piece of spalted maple that's 1" thick.
How does say...shipping and a pendant for the wife sound?
Stump
How does say...shipping and a pendant for the wife sound?
Stump
Stump, sounds great. Thanks! Let me know in a PM what I owe you for shipping and your PayPal address and I'll get that sent over. And send me your address too so I know where to send the pendant when it's done.
Just a heads up: It won't be until sometime in September that I can get to making the pendant, if that's ok with you. I'm having surgery the end of next week and expect to be out of the shop for a few weeks while I recover.
Just a heads up: It won't be until sometime in September that I can get to making the pendant, if that's ok with you. I'm having surgery the end of next week and expect to be out of the shop for a few weeks while I recover.