Minimum 6 wide 10 would be better. Could also trade
looking for QS sycamore CLOSED
- Thread starter pvwoodcrafts
- Start date
Are you looking for dry or will green work? I milled a short heavily branched section that would yield a little from the center cuts if green works. I dont have pictures and it's raining right now. I could snap a couple pics this evening when I get back from my job. You know, that thing that helps pay for more wood stuff... :) off hand I would say my slabs are 18ish by 30ish and just under 2 inch thick. I would be willing to break them down to your size however, since that size isn't going to ship economically. Anyhow, that all depends if green suits ya to begin with.
- Thread Starter Thread Starter
- #3
Yeah I need 4/4 dry stock. thanks
Ok. Will keep an eye out. What length you after? I note 6 to 10 inch width...
- Thread Starter Thread Starter
- #5
Gamebox 24"
thanks
thanks
I think I have some in the barn. I will check on what I have.
I finally got what I have out of the barn.
The last 4 pictures is the 4 sides of the large piece.
I have a fair amount of QS sycamore that would be available if you haven't already gotten what you need. Some has the real distinct grain, and some a more refilned, uniform ray fleck. The first picture shows the two types of QS fleck side by side. The next two pictures are close-ups of the different fleck. Boards are about7.5" wide. Not all are surfaced, but I can do that. Surfaced thickness is 3/4 - 1". I don't really sell lumber, and I've never shippped any lumber before so I'm a bit apprehensive about what that entails. How large of a piece or pieces are you looking for? And what is a fair price? Last three pics are off topic, but are of sycamore I had milled last week. Wish I had a kiln, because the wood is still wet. But those were big puppies -- yielded some 24-28" live edge slabs and a bunch of 12+" boards with beautiful fleck. Let me know if you want more information or more pictures of the wood I have available to sell.
I love qs sycamore. It's amazing how the two sides of the same board can look so different.
Bill
Bill
@Bill12035
Did you receive these?
Did you receive these?
I didn't purchase it. I was told in a PM that @pvwoodcrafts purchased them.
Ok then, @pvwoodcrafts did YOU receive these?
- Thread Starter Thread Starter
- #16
Received everything. Was leaving post open to see if there was anymore out there
Ok. Now it's at the top again. I'll leave it open then. I'll talk to my buddy and see if he has any too.