Silver maple natural edge bowl

TimR

Sawdust Engineer
Full Member
Messages
6,276
Reaction score
10,758
Location
Lake Park, GA
First name
Tim
Background story, this was a gnarly natural edge piece of maple given to me by a friend about 10 or 12 years ago. Sat on shelf, It looked like it had some figure and I was tempted to post it in WB, but I was leery about inside. Needed some aggressive dressing with electric planer just to get a side flat enough to mount to a chuck. Dry as a bone, took several passes with hollowing rig to maintain control and minimize bark loss. First time Ican recall doing similar with no CA to stabilize. About 11” wide, 5” tall, 1/4”thick. Tung oil finish.

IMG_6326.webp IMG_6325.webp IMG_6324.webp IMG_6323.webp
 
Beautiful. I don’t have the stones to turn a blank like that. Did you have any challenges other than a getting a flat spot for a chuck?
 
Background story, this was a gnarly natural edge piece of maple given to me by a friend about 10 or 12 years ago. Sat on shelf, It looked like it had some figure and I was tempted to post it in WB, but I was leery about inside. Needed some aggressive dressing with electric planer just to get a side flat enough to mount to a chuck. Dry as a bone, took several passes with hollowing rig to maintain control and minimize bark loss. First time Ican recall doing similar with no CA to stabilize. About 11” wide, 5” tall, 1/4”thick. Tung oil finish.

View attachment 294084 View attachment 294085 View attachment 294086 View attachment 294087
Outrageous beauty!
 
It’s very nice! I really like the first picture, the way it sits. Like you’re looking right into it as you approach it.
 
  • Thread Starter Thread Starter
  • #8
Beautiful. I don’t have the stones to turn a blank like that. Did you have any challenges other than a getting a flat spot for a chuck?
Biggest challenge is dealing with interrupted cuts almost all the way through.
 
That would look really cool with a small bonzai plant inside. With the one side being low like that it's like a display piece. Well done!
 
  • Thread Starter Thread Starter
  • #12
Wow! I never turned bowls. This looks like an exercise in ballsyness.
Can be more of a challenge with interrupting cuts plus bark and rolled over rim. I treat this kind like a hollow form with a big opening. Also, I keep speed down to about 650 rpm and sharpen tools often.
 
Back
Top