Last summer I ordered an Alaskan mill from Granberg and have now used it a few times. I learn more each time I use it.
I thought that I would create a thread here to share some of those efforts.
Reading Greg's thread put the idea in my head. https://woodbarter.com/threads/chainsaw-sawmilling.45766/ @woodtickgreg Then going down the rabbit hole on the Tube.
My mill is a 36" Granberg Alaskan Mill. The saw is a Husqvarna 562xp which translates to a 60cc pro saw. I run a 32" bar on it with Granberg milling chains. When not milling the saw wears the factory 20" bar and standard chains.
Most Alaskan mills use the largest saw / bar combination possible. And weigh 70+ pounds fully dressed. My setup is intentionally smaller. I work by myself most of the time and have no desire to sling 70+ lbs of saw & equipment around. This intentionally limited the size of tree that can be milled to a size that I can move around, load, and stack by myself. Max slab width is about 28". The largest log that I've tried so far was the Cedar Elm shown below which was around 22" across. The little 60cc saw handled that just fine.
I thought that I would create a thread here to share some of those efforts.
Reading Greg's thread put the idea in my head. https://woodbarter.com/threads/chainsaw-sawmilling.45766/ @woodtickgreg Then going down the rabbit hole on the Tube.
My mill is a 36" Granberg Alaskan Mill. The saw is a Husqvarna 562xp which translates to a 60cc pro saw. I run a 32" bar on it with Granberg milling chains. When not milling the saw wears the factory 20" bar and standard chains.
Most Alaskan mills use the largest saw / bar combination possible. And weigh 70+ pounds fully dressed. My setup is intentionally smaller. I work by myself most of the time and have no desire to sling 70+ lbs of saw & equipment around. This intentionally limited the size of tree that can be milled to a size that I can move around, load, and stack by myself. Max slab width is about 28". The largest log that I've tried so far was the Cedar Elm shown below which was around 22" across. The little 60cc saw handled that just fine.
Last edited:



