- Thread Starter Thread Starter
- #181
Very!
Projects I don't post (normally)
- Thread starter Phil.H
- Start date
- Thread Starter Thread Starter
- #182
Wife and I dressed up for a 50 and 60's party. I needed a pack of cigarettes to roll in my sleeve so I made one.
Did you turn individual cigs to go inside the box?
Clever
- Thread Starter Thread Starter
- #185
Working on lately.
Odd shaped punky, rotten piece of cherry I picked up off the ground. Not sure if it will stay together enough to finish!
Razor thin in spots and chunking off in others. Also extremely out of balance! Can only go to 600 rpm.
Odd shaped punky, rotten piece of cherry I picked up off the ground. Not sure if it will stay together enough to finish!
Razor thin in spots and chunking off in others. Also extremely out of balance! Can only go to 600 rpm.
Last edited:
Throw it away and find something else, Phil!
- Thread Starter Thread Starter
- #187
Nope. Follow through to the end. Even if it kills me. Lol!
Put on the bandsaw and cut a smaller bowl. Then turn it .
- Thread Starter Thread Starter
- #189
Wife grabbed a pic to show the size of this thing.
A LOT bigger than I had imagined!
- Thread Starter Thread Starter
- #191
Quick little 2 X 2 box out of ash or elm. Just wanted to make something!
Ben busy with outside work and apartment house projects.
Got some decorations up also. Doesn't look like this anymore. Will grab an updated pic when I can. Also working on a small Halloween project in the shop.
Ben busy with outside work and apartment house projects.
Got some decorations up also. Doesn't look like this anymore. Will grab an updated pic when I can. Also working on a small Halloween project in the shop.
- Thread Starter Thread Starter
- #192
3D ghost ornament made with the laser and a scroll saw. Hangs by a magnet and swivels on a wooden pin.
