Rubio-like finish from scratch

I sent a note to Chris ( @Kalai ) but he hasn't been on lately so haven't heard back yet. I've got a box in the works using some of that milo I got from Chris. The last time I used some, I learned the hard way it doesn't like finish because it's so naturally oily. So my question is - what's the best way to finish it? None at all, simple sand and buff? Wax and buff? Some kind of oil like this Rubio stuff? Any recommendations are appreciated - except for any involving milking wild animals, sourcing illegal dangerous toxic or radioactive chemicals, or whale ambergris.
I've not used any of the Milo i got from Chris (or any Milo at all for that matter), but I've never encountered finish curing issues with oily woods other than Argentine lignum vitae. I did some test pieces of that stuff with oil poly, and it took about a month to stop being tacky. It also looked like crap when it did finally cure. So on my projects with Argentine lignum, i seal them in dewaxed shellac.

The Irish flag bottle opener has Argentine lignum, and that needed shellac. The German flag bottle opener has bloodwood, and oil poly cured perfectly fine on that.

20250403_231017.webp
 
Thanks guys. I tried the shellac method on that box with the milo trim pieces and didn't get a good cure. Maybe I didn't let the shellac cure long enough, or put on enough coats. Not sure. I think I have a can of oil based poly so maybe I could try that. But I'm starting to just lean to sanding to very fine grit and buffing. I don't want to wait a week or more to finish the inside surfaces of this box before I can glue it together.
 
Thanks guys. I tried the shellac method on that box with the milo trim pieces and didn't get a good cure. Maybe I didn't let the shellac cure long enough, or put on enough coats. Not sure. I think I have a can of oil based poly so maybe I could try that. But I'm starting to just lean to sanding to very fine grit and buffing. I don't want to wait a week or more to finish the inside surfaces of this box before I can glue it together.
Shellac is a non-curing finish, so I'm guessing you needed another coat. Shellac is just a hard resin dissolved in alcohol. When the alcohol flashes off, you're left with only the resin. The resin doesn't oxidize like the resins used in other finishes, so it's in its final state once the alcohol is gone.
 
Do you know what cut of shellac you used? Like Ry said above, you probably just needed another coat or two or three of the shellac.
 
My shellac was a 1 - 1.5lb cut. I started with a 2lb cut, poured a little in a second jar and added a little more alcohol, so it wasn't completely accurate. This is what I used to French polish those two guitar bodies.
 
Last edited:
Relative thin cut, so I'd probably use at least three coats of that to completely seal. Tough to tell though as everybody applies a little bit differently.
 
Back
Top