Table saw outfeed tables

[woodtickgreg]

Thanks so much for the very thorough tutorial! Two questions, first, what router bit did you use to make the miter slots on the outfeed table, and second, how did you attach the Maple spacer to the Table Saw? Thanks! Chuck

It was just a straight cut router bit about 1/2" in diameter. Only one I had with a 1/4" shank for the small router I used. I really like this small router, not as powerful as the larger routers I have but way easier to handle.
When I removed the old table I left the mounting bracket on the saw, it is just a flat strip of steel and it already had three holes drilled in it for screws. So I just held the wood up to it and marked the holes, then pre drilled them and ran the screws in and out before I mounted it on the saw. I'll get a pic of it later for you.

 

[DLJeffs]

Just looking at those last two photos... I think you're going to need a bigger shop.

 

[woodtickgreg]

Just looking at those last two photos... I think you're going to need a bigger shop.

We always need a bigger shop. Lol. That's why most of my tools are on wheels, everything except the table saw, it never moves.

 

[woodtickgreg]

@Nature Man here's the pic of how the board is mounted.
Hopefully you can see the 3 screws holding the spacer board on.

Used it today, so nice to just push a board through and let it lay on the table and not have to worry about catching it.