What did you do in your shop today?

Not sure, was going from Dutches to Rockland, and found roads not to be traveled again by me. We spend more time in Central NY, but have been known to just get in the car and drive, somewhere, anywhere....If health holds, maybe a trip to make again next year.....in your neck of the woods....
 
I cleaned my shop and learned-

1- I have 4 bandsaw blades that don't fit any saw I've ever owned
2- I have 6 sleeves of 3M 240 grit sheet paper but only one sleeve of 320 (I'm still trying to figure out when I bought all that 240...)
3- Spilling a bag of steel shot on the shop floor makes a mess
4- If you throw out all the shot brad point bits there is a lot more room in the drawer.
5- dropping your tenoning jig on your foot makes you say bad words
6- I need a bigger shop.
 
Dude....yours and your wifes day went to hell without stopping at go to collect $200....
 
Lets see.....Minnesota...Connecticut.....hmm...I think I have a fairly decent buffer zone there..
But ...even still...don't poke the bear.
 
Are those normal sized carpenter pencils Brink? Got so used to having a Bic lighter by everything its hard to judge size.....
 
I was going to do a thorough cleaning of the garage shop this afternoon, but some much welcome rain put that on hold and I'll try to do it tomorrow.

Instead I worked on some pens. Got some turned, but neither sanded nor finished. Going to turn some more before moving on to the sanding and then finishing steps - I like to do me steps in making pens in batches as it really shortens the amount of time spent on each pen. (I really enjoy making these, but don't want to waste precious shop time either!)
 
You must log in or register to reply here.
Back
Top