WTB: turning tool with outrigger arm for hollowing

[Nubsnstubs]

Here are few pictures of one of the hollowing tools I made
This side is for forward turnings.
This side is for reverse. This shows the cutter on the reverse
This last pic shows the forward side. The cutter is on the other side and takes seconds to remove and install on the side needed I hope this helps. I have some aviation drill bits that I used to drill the screw hole and center the cutter at the same time. CRS is setting in and I can’t remember what the bit is called so can’t say what you need to center the cutter.
The bar is 1/2” 4140 chromemoly steel. ………Nubs

 

[Nubsnstubs]

Here’s a picture of the bit. They are pretty expensive, but do an excellent job

……… Nubs

 

[SA-Motors]

Hi Nubs -- thanks for the photos and info. I'll flatten both sides like you've done to make it reversable. Some day I might get a reversible lathe. Thanks!