woodtickgreg
scroll, flat, spin
Staff member
Administrator
Global Moderator
Founding Member
Full Member
Forum Moderator
- Thread Starter Thread Starter
- #12,541
After chopping mortices I decided to correct the angles on my morticing chisels
I tapped some 80 grit cloth paper to my table saw top.
And I came up with this. The secondary level should have been shorter.
Im still working on it but I'm up to 320 grit now.
It's not done but its sharp enough to cut my finger.
The new jig works far better than the old one.
I tapped some 80 grit cloth paper to my table saw top.
And I came up with this. The secondary level should have been shorter.
Im still working on it but I'm up to 320 grit now.
It's not done but its sharp enough to cut my finger.
The new jig works far better than the old one.