I went old school today. I wanted to put a large bevel on the bottom edge of the top of that hall table I'm making with the ambrosia maple top and legs. I couldn't figure out how to do it with the router bits I had and trying to run that thing on end through the table saw was too dangerous. So I went with a hand plane. Drew my lines, clamped the top to my work bench and started rocking back and forth. Turned out just like I wanted. The end grain bevels were a little tougher, had to make short choppy cuts going with the grain rather than cross grain cuts. A little work with a sanding block and the bevel is done. Next up sanding the legs and shelf and then getting ready to glue it up.
